RADIANT HEATING IN A CONCRETE FLOOR

• Can also be installed under light concrete on a plywood floor
• Can reduce heat transfer as much as 2" of rigid insulation
• Keeps the heat inside
• Increases the heating system efficiency
• 60 PSI crushing resistance
• Helps to radiate the energy in the slab back in the room

1. UnrollAYR-FOIL™ over the sand, aluminum side facing the ground (white side up).
2. Overlap the seams by 2". Let the material go up 6” along the wall.
3. Seal the seams with AYR-FOIL™ white vinyl tape (2" wide).
4. Install the wire mesh and the piping system following the manufacturer’s recommendations.
5. Pour the concrete on top of it.